Oil filter

Auto Doc's

Lawn Addict
Top Poster Of Month
Joined
Sep 7, 2024
Threads
17
Messages
1,321
Hi Slomo,

I used that trick years ago when I worked in an automotive shop. We occasionally would have a vehicle that the drain plug would not seal properly on. Applying a vacuum to the filler and then quickly switching the drain plug worked pretty slick.

Not sure how that would work with an oil filter change on a rider engine. Maybe it will draw the excess oil out of the oil filter if left to set for a few minutes.
 

slomo

Lawn Pro
Joined
Jul 14, 2019
Threads
80
Messages
5,696
Oil is too heavy to get into the vacuum. Way up on top of the engine so to say.
 

Rivets

Lawn Royalty
Joined
Mar 11, 2012
Threads
61
Messages
15,656
Back when I was teaching, ran into this problem on a wide variety of engines. Made about a half dozen what I call oil troughs. Here’s what I had my students do. Get a piece of polyethylene plastic about 6” X 8”X1/8”. Get a new or cleaned up used filter you need a solution for, two work better, plus a heat gun and good gloves. Slowly heat the plastic to the point where you can form the 6” side around the filter, making a tube. It does have to be completely closed. When it is cool you may have to cut the tube back so you can turn the filter. When you want to change the filter, loosen the filter a little and then slide the tube over the filter, tight to the block. Finish removing the filter and oil runs out the tube into your drain pan. Label tube with paint pen and put in storage for future use. Students got to keep theirs, but I also kept left overs as spares. Might have to do a little rework to get them to fit right. Not perfect, but does save a lot of cleanup. PS: Found milk jug plastic to thin and flexible.
 

Skippydiesel

Well-Known Member
Joined
Nov 29, 2020
Threads
13
Messages
271
All way too complicated - I use a piece of malleable aluminium flashing (replaced lead).
Can be purchased from the hardware in a small role.
Its thin enough to cut with scissors (best with metal shears/snips), soft enough to be easily fashioned into a trough, that will hold its shape.
Can be reused indefinitely and you will find lots of other uses for malleable aluminium. 😈
 

Rivets

Lawn Royalty
Joined
Mar 11, 2012
Threads
61
Messages
15,656
Metal was a material I tried, but found that it would not hold its form. Easily distorted especially the area around the filter. Plus it had sharp corners and edges, which caused an increase in the bandaid supply. I forgot to add that once you size the plastic around the filter, heat the plastic one more time and end in slightly, giving the tube some tension to cling to the filter.
 

Skippydiesel

Well-Known Member
Joined
Nov 29, 2020
Threads
13
Messages
271
"Metal was a material I tried, but found that it would not hold its form"

Obviously you did not try aluminium flashing. Its designed to be easily formed by hand, no tools or heating required ( similar to the lead flashing it replaces) and hold its form 😈
 

sgkent

Lawn Addict
Joined
Sep 27, 2017
Threads
35
Messages
1,931
did anyone look at the Amazon link I posted? These things are incredible.

12-04819d.jpg
 

SeniorCitizen

Lawn Addict
Joined
Aug 28, 2010
Threads
144
Messages
2,321
Yes , that would be convenient if i could find it when i needed it .

If the Form A Funnel man would do it as i do it , he wouldn't have those streams of running down the side .
 
Last edited:
Top