Search results

I have a ball valve for as a quick oil change on my lawn tractor and the pipe into the valve is a 3/8 npt and I like to purchase a male plug for the other end and I can’t determine the thread size on the opposite side. I bough a 3/8 npt SS plug and it was much to large.

After looking at this mower and reading the specs it appears to be an excellent entry/residential Zero turn. It comes with a Kawasaki engine and the transmissions are the hydro gear 2200 which are a step up from the ones that come on the Exmark Quest entry level Zero turn. Is there someone here...

My Honda HRN 21 inch mower had some debris & caked up oil on the block of the engine and I was wondering if it’s safe to spray on a degreaser ( heat the engine first?) on the engine and then spray the entire engine with water from a pump sprayed.Is this the best way to clean the mower?

The mower has the normal pre-determined cutting height and most are all too low while the the last (highest) notch is used most of the time. Would a know if I could raise the deck so that all of the pre determined height woul be a quarter or half inch higher?

I have a CC with a Kohler twin with the pull & twist drain valve. It seem as though oil is slo leaking out once the engine is running with heated oil and I’d obviously like to fix this. There are lots of YouTube videos associated with this but there’s something that I’m not understanding and I’m...

The new Sheetz gas station near our house happens to sell ethanol free fuel, however the octane rating seems to be 90 (instead of the usual 87) Is this higher octane safe for my Kohler VTwinand for my Honda self propelled mower?

I’ve noticed that my poly can’s flexible nozzle leaks where it’s attached to the can and after a closer look, I noticed the rubber gasket was all cracked into small pieces, some of which were missing. Now I can only assume that some are in the container so I’m going to pour all the gas out of...

Wanting to cut in a shut off valve on my Cub Cadet lawn tractor and wondering if the best location would be to install the valve where the fuel filter is in the photo and move the fuel filter to the left of the hose clamp that anchored to the block? Thanks

Live in SW Virginia with a 4 month moderately cold winter and I keep my Cub Cadet 42 tractor in a shed with a push Honda mower. The tractor battery stays in tact but I do keep it connected to a battery tender. Is it better to complete run the engines dry of fuel (with an empty tank) or, as I...

I‘ve been using mulching blades on my Cub Cadel 42 inch along with the discharge plug and it always leaves lines of cut grass if cutting the lawn when it’s even slightly high. Im wondering if the mulching blades with a side discharge would give better results, had anyone done this before? I do...

For some reason it seems as though the oil filter on my lawn tractor gradually loosened up with use and I now have oil & debris covering the lower part of the engine and heavily covering the front frame below the filter & oil drain tube. Im thinking I should spray on some degreaser and either...

I’m wondering if there’s an easy way to drain gas from the carburetor since the engine has been surging at low rpm’s so I’m guessing it’s a fuel related issue?

looking to install a gas shut off valve on a Koehler Twin engine and it appears as many of the ones on Amazon have bad review. Are there better ones out there or just the ones that are sold on Amazon?

I cut the grass today for probably the 3rd time this spring and when finishing up and turning off the blades and lowering the throttle, the engine sounded choked out and sputtered at the lowered rpm’s? If this continue, what’s my next move, completely drain the fuel tank and change the fuel...

I have a CC XT2 lawn tractor and the battery is 6 years old and i keep it tendered for the winters here in Virginia. I’m thinking I should just replace the battery prior to this years season, or, do you get a warning prior to the battery just going completely dead? Thanks

Most all oils are now synthetic so I’m guessing it’s okay to use them in my walk behind Honda mower and my Cub Cadet 42 inch lawn tractor?

I have a 42 CC lawn tractor that I keep in an unseated shed for the winter. Should the battery be on a tender from now until spring or do I use the tender just three or four weeks before I’m ready to use it again in the spring? Thanks

I have a CC lawn tractor with a 22 hp Koehler twin engine and it’s about 3 yrs old. Two seasons ago the engine was surging and eventually it stopped so I was thinking it was a fuel issue. Now today, for the first time this season, I’m noticing that it’s surging again and I only notice it at half...

I just purchased a Honda 21 inch walk behind mower and it has a valve on the fuel line. I believe this is used to allow the engine to use all of the fuel in the carburetor so it’s dry when storing it for the winter. Is there any other time this valve is useful to use for any other reason?

We have a 1/2 acre of property and I do almost all of it with a 42 inch CC lawn tractor. There is a small section that needs to be cut with a walk behind due to a slope and the back yard has about 8 small trees that take a bunch of time to circle with the tractor. I was thinking of a HD Honda SP...

It seems that most start problems I have with my Toro mower have to do with the carburetor gumming up. Is there a good gas treatment that I could continually use that will help to ensure the carburetor stays clean? Thanks

We have a 1/2 acre of property and I cut the grass with a 42 inch Cub Cadet lawn tractor and use a string trimmer to edge and trim all of the grass areas that I cannot get to with the tractor since we also have a lot of bushes and trees. Ive been thinking of getting the battery powered EGO from...

Would one or the other be better for a 22hp Kohler twin engine?

I was wondering if this is a decent Zero turn for a 1/2 acre with a bunch of small trees and bushes? The cost is around $3K so I realize it’s certainly not a commercial mower. I currently have a Cub Cadet 42 inch lawn tractor that is only a few years old, however I would love to have a Zero turn...

I bought a mulching plug for my CC XT1 about 2 years ago and fit is good, however it’s not secure enough on the bottom and grass clippings always accumulate and work their way through it. I wondering if the newer ones are any better?

I’m guessing the best way to keep the deck clean is to buy a front end lift and scrape it manually after each 2nd or 3rd use? is this best and what would be the least expensive front end lift? I’m guessing those plastic tip ramps are useless? Thanks

My neighbor just serviced his craftsman lawn tractor that has a 21 or 22 hp engine, single cylinder and he changed the oil and guessing he over filled it since the thing sent out huge clouds of white smoke. I went over to help him and the cylinder head and spark plug area was covered with oil...

Storing the lawn tractor for the winter in Virginia and wondering if it’s best to start tendering the battery now in December for the next 4 months or just tend it weeks or a month prior to spring?

My generator, which I have not run in the last two years is now running however it runs with the choke pull in the pulled out position only. According to the symbol, is the choke on or off in this position? If I push the choke lever in, the unit stalls.

I have a single cylinder 15 hp generator that I have not started in 3 years but did so today. Apparently the engine only starts and runs when fully choked. If I attemp to un-choke the engine, it stalls. What’s the deal?

I have a CC 42 inch with a Kohler Twin Courage engine and I bought the tractor at the beginning of the season last year. It seems that when the deck is not engaged and the engine is running in any throttle position, the engine does not running at a consitant speed. Sounds like it pulsates at...

I looked on the CC site as well as my owners manual and did not see a torque spec. Guess I just tightened it well with a 1/2 drive breaker bar or guess at 80 lbs or so?

Thinking of going with this accessory so I can lose the large chute, get closer to obstacles on that side of the deck and not shoot grass clippings to the one side. Can anyone attest to the effectiveness of the mulching blades?

Going to change the oil for the first time on a Cub Cadet With a 3 inch OD oil filter and guess I will need a filter wrench to remove tbe factory installed filter. Most of the wrenches I see have horrible reviews, does anyone know of a decent one to purchase?

Live in Virginia where it gets fairly cold in the winter and my new tractor is in a backyard shed with no heat or electric to keep a battery tender attached. What is the best way to deal with this? If I start and run the engine for 20 minutes once a month or let the battery die and tender it...

I have a new CC lawn tractor and thinking of getting the optional mulching kit. Can anyone tell me how the quality of the cut is with with this kit? Also, what would be the easiest way to change the blades without a lift?

I have a new Cub Cadet 42 inch lawn tractor with a Kothler Vtwin and the first oil and filter change is listed at 50 hours. I have a 1/2 acre lot so I might go all summer until I reach 50 hours. Should I follow this recommendation?

I bought a new CC lawn tractor with a Kohler V Twin. Should I use Kohler oil when saving the engine or another high quality 10-30 motor oil?

Going to purchase a Cub Cadet.. One of the CC models has a Kohler Courage 18 hp single, the other has a Kohler 22 hp V Twin. Which engine would be more reliable??? Thanks

Does JD actually make their own VTwin engines for their lawn tractors?

Although I only have a 1/2 acre, I would love vet to own a ZT but I am thinking a low end ($3K ) Zero Turn would not be as reliable as a Lawn Tractor since the ZT's are more complex with the two transmissions and more prone to having problems than with a Lawn Tractor. Is my thinking correct??

I have slightly less than a 1/2 acre of grass and would like to purchase a lawn tractor for $2 K or less. I am trying to decide between a Cub Cadet or a Husqvarana since those have authorized service dealers nearby. Is one of these two brands more reliable than the other and are parts and...

Not sure if I misinterpreted a comment in a thread so I need to ask the question. Are the lawn tractors being sold by Lowes and Home Depot being manufactured to a lower standard to minimize the pricing? Thanks

I have a Toro recycler with a Tecumseh engine and the only problems are always related to the carb needing to be cleaned, at least according to the repair shops. I run the mower dry for the winter, treat my fuel with stabilizer and always use premium fuel. What else could I do to prevent his...

We live in Virginia and have a house on a full half acre. Are there any really good mowers wider than the typical 21 inch mowers? I would love to own a commercial 36 inch mower but find it different to spend $3K for a Toro, Gravley or Xmark. Also think spending $2600 or so on a Zero turn might...

Recently moved to Virginia and have a little less than a half acre of grass. The property has gradual slopes and the average amount of trees and obstacles on the lawn. Would like to get a mulching mower that could also bag and I wold like a 190 cc engine for powering through wet grass. What...

Moving to the Roanoke area and will have a house on .56 acre. I can really really appreciate the job that a commercial mower does in making cut grass look really good, not to mention using a top quality mower. I looked briefly on line at EXmark mowers and to buy a new 36 inch mower would be...

Have a Toro and it is about 10 hers old. Always starts right up and for the winter I let it run out of gas. Today I tried to start it, about 50 pulls and there is no way it will start. The spark plug looks good. What do I do rather than bring it to a shop? Thanls

So regarding all of the small engine issues, both 2 & 4 cycle that are causing carborator,fuel problems, I was told to use only premium grade fuel Is this true????

Had my Echo pan pack blower survey for the first time since it would not run when squeezing the throttle. The shop said it was the ethanol in the regular gas that attracts water and then gums up the carburetor. His advice was to use high octane gas and it is only good for some 2 months and fuel...