I had this saw for about 4 years and in the beginning of this year I was using it to cut some trees and it shuts off after using it for almost the whole day. There was still gas and oil in it when it died, so I left it and the next day I tried starting it but it'll start then boggles down and died. I cleaned the old carburetor, then adjust the carb, and tried starting it and again it'll start but boggles and died, but it'll stay on as long as i hold the trigger, but as soon as i left off the trigger the pole saw just dies. Next, I replaced the carburetor, spark plug, but it does the same, boggles and die, then i replaced the ignition coil, fuel lines, and fuel filter, but even then it didn't work. I also notice that if i come the next day the gas in the primer bulb is gone and when I remove the cover I can see gas leaks, but this was before i replace the fuel lines. So what's causing it to not start or stay running since i replaced most parts? I also made sure that every parts are tighten and I also forgot to mention that the spark arrestor screen was removed, but the pole saw still don't work.
Last edited:
