TB360 Rattles when running until I pull on rope to tighten then stops

[Swordfish80]

Hi, I have a TB360 190CC. For the past couple years when I am cutting with it, it rattles like a chain a loose. Once I tighten the pull start assemble rope and hold the rattle disappears. I am wondering if I were to buy a hole new pull start assembly will this rattle disappear, or is there a chance it is something else. Pull start assembly is in good shape.
Thanks in advance.

 

[Rivets]

Please post the engine numbers so we can see what recoil system you have.

 

[Swordfish80]

Sorry I am new not sure if this tells you.

 

[Swordfish80]

Sorry I am new not sure if this tells you. View attachment 62417

Thank you

 

[Rivets]

Look on The metal housing which has the recoil attached for the engine numbers. The pic you posted is an EPA tag only.

 

[Fish]

Probably just needs the pull rope wound one loop tighter.

 

[Fish]

Or there could be some slop in the rivets that bolt the starter on to the housing.

 

[Swordfish80]

Look on The metal housing which has the recoil attached for the engine numbers. The pic you posted is an EPA tag only.

Ok I found the Engine Model is 121S 02 0068 F1

 

[Swordfish80]

Probably just needs the pull rope wound one loop tighter.

Can this be done without disconnecting the rope and putting it back through the holes? Sorry I am trying to learn how to work on this stuff

 

[Fish]

Can you take a pic of the top of the engine? So we can see the starter better?