Oh, the advantages of living north.

I would have to say that is one for the record for me. Never heard of frozen spindles in any state much less Georgia. Just goes to show a fellow to never say never.
 
possum said:
I would have to say that is one for the record for me. Never heard of frozen spindles in any state much less Georgia. Just goes to show a fellow to never say never.
Click to expand...
First time for me. But it is only in the 20s. The news just said wind chill in the mourning of -30 with a whole inch of snow
 
possum said:
I would have to say that is one for the record for me. Never heard of frozen spindles in any state much less Georgia. Just goes to show a fellow to never say never.
Click to expand...

I would say you have some serous bearing problems if they got that much water in them. I am going to say they sure must be lacking in grease. I have rode snowmobile in -20 and have to say I never had a bearing freeze but I have had the skin on my face freeze. Still got the scars from it.
 
Mike88se said:
That's my thoughts exactly :thumbsup: South Texas born and bred. Anything under 60F w/o sun is cold to me lol. I just wrapped my sister's water pipes. It's cold as **** out there :thumbdown:
Click to expand...

My definition of cold is anything under 30F.
"Too damn cold" would be anything under 20F.
If it's subzero temps out there, someone else can do the plowing. Screw that crap.
 
If I could afford it, I wouldn't plow in the winter. Unfortunately, I have no choice.

Sometimes I wonder why I moved to Michigan...:confused2:
 
reynoldston said:
I would say you have some serous bearing problems if they got that much water in them. I am going to say they sure must be lacking in grease. I have rode snowmobile in -20 and have to say I never had a bearing freeze but I have had the skin on my face freeze. Still got the scars from it.
Click to expand...

Might be because I cut wet grass and when it is raining. As you know spindles use sealed bearings and will let water and dust past them and into the housing. So really was not a bearing that was froze but maybe the shaft and or the bearing cover on the bottom where the blade is.

My bearings DO NOT lack grease. I just repacked them two weeks ago. I pop the seal off and repack them every 50 hours.

Used the mower today and all is fine no bearing noise at all.

I do more preventative maintenance then anyone you will ever meet. I have OCD when it comes to mower upkeep. But this is why my $1300 mowers last over 1000 hours
 
I dont care for winter but I just take it one season at a time, and I am glad when spring rolls around. Winter brings its whole set of challenges that make it ok I just like warm weather better these days.
 
You must log in or register to reply here.
Back
Top