banshee350
Member
- Joined
- Jul 17, 2011
- Threads
- 11
- Messages
- 29
I have had this problem where when you pull the pto switch the blades dont always engage. Sometimes they will after a short delay other times I just keep trying the pto switch until they engage. When it is running with the blades off it shows 12v on the gage. This time after mowing for about an hour I noticed the volt gage reading just below 12v. If you turn the clutch off it wont always engage the blades. After I turned the mower off and tried to restart the battery seemed dead. I am used to having an altanator like my 321d and this is the first mower I have had that uses a stator for charging. the battery is a couple of years old. Not sure where to start,
replace with a new battery
replace pto switch
replace voltage regulator
Replace mower clutch
any suggestions?
replace with a new battery
replace pto switch
replace voltage regulator
Replace mower clutch
any suggestions?