Recent content by hlw49

How did it run before you changed those parts? If it is a 10 Micron filter it can cause the engine to starve for fuel since the engine does not have a fuel pump.

I have used a solenoid for an inerta drive starter and wire it basically the same way. I use 10 ga wire from the engine starter solenoid and back to the exciter terminal on the engine starter. You don't have to run a ground wire from the solenoid since the solenoid grounds to the frame when you...

We have fought the belts like that on several mowers. Finally got an after market raw edge belt and it solved the problem. Dealer is right the wrap belts can cause a noisey deck. Like he stated ever where there is a joint in the wrap there is a bump in the belt. I have seen belts with four to...

The people of America have spoken. The American people have spoken.

Did you ever find the problem? It is an awsome engine and very seldom blow head gaskets. Dixie Chopper quit using Generac engines around 2014 due to the fact they started dropping exhaust valves. While trying to meet EPA emission standards instead of revamping the engine to meet the standards...

Could you bolt the shock to the frame and them lift the body to line the holes up. Never tried just a thought.

Yes The engineers a Hustlers are a bunch of idiots. Anybody that would bolt a muffler to the frame is not too smart. The engine and the frame flex differently. Have seen a lot of the Hustler mufflers break because of this.

Take the top cover off the engine. Most of the engines have a half inch headed bolt with a torques star in the center of the bolt head.

Need complete model and code nol

Did you check the fuse? Can you hear the fuel solenoid click in?

Thanks I'll give it a try

Thanks

Ever think the crank shaft might be bent? The farther away from the bottom of the engine the worse it would be and this where the clutch in mounted. Should be able rig some thing to check it. Just take the clutch off and check it.

YW

What ever works for you.

https://www.dixiechopper.com/wp-content/uploads/2020/06/4420784-blackhawk-safety-operation-and-maintenance-manual.pdf Hope This helps

If the pump is making a loud whinning noise it is usually the pump. You can have it checked with a flow meter and pressure gauge. Wheel motors usually feel like it is quivvering, Kind of like a chattering.

Check the ground cable from the battery to the engine. It bolts on the starter. Also check the wires on the electric clutch to make sure they have not gotten cut by the motion belt and shorting out.

What have you guys found to be the best stuff to glue a seat back to the seat pan?

Take out the plug leave it out and fill the hydro through the expansion tank. It will hold about 2 quarts. You can then finish filling the hydros after you put the plug back in. You will see bubbles coming out of the hydros into the tank until full.

Buy the Xtreme clutch it is head and shoulders above the rest. Have been using them for years and have yet to replace one. Usually about half price OEMs.

Get them in all the time where some genuis used a pry bar between the pully and the belt guide tabs. Then you have to get it off. Drill holes in the pulley and use a harmonic balance puller run bolts through the puller and the holes in the pulley and put nuts on the top of the pulley. I put an...

High fuel prices cause higher prices across the board. Drill baby baby. Vote for the right Man.