Recent content by Bertrrr

Look at the spec sheet on both, mainly the footprint / mounting bolts , shaft size etc.

what size is the largest one ? If it's under 2 inches in diameter , the O ring kit will probably have it

Not sure what size the o rings are but an O ring kit may have one you can replace it with , I've had to build o rings in the past with o ring stock and superglue when push comes to shove

Pull the motor and remove the seal, there should be a number on it for replacement , I'd get 2 so you'll have a spare

By the bottom are you referring to the crankshaft ? is the piston going up and down ? , Pull the spark plug and watch your piston to see if it's moving, it should roll very easy with no compression , you can put a rod through the plug hole and watch it move with the piston , if no movement you...

Will it roll 360 degrees in any direction ?

I worked on one and found the drive motors were missing some bolts, throwing belts and stuff, maybe look at your mounting hardware in that area

So it does not turn over ? or doesn't start ? two different problems for the help you need

Sounds like ignition switch issue, after the starter is engaged it should return to ON position and retain power to the ignition coils , they're not expensive to replace

Drain and change your oil first, if there's gas in the filter, there's gas in the sump too. Can only get in there from the carburator as far as I am aware. You should see higher than normal oil level when gas is present. Sometimes this happens when your machine is sitting over night or for a...

If the flywheel key is only slightly sheared , it aint starting