PeterJones
Active Member
- Joined
- Jan 3, 2017
- Threads
- 11
- Messages
- 58
Hi,
I have recently replaced all three cutter blade spindles on my scag cheetah. I have installed the new spindles and, unfortunately, decided to grease them post installation.
My problem is that two of the grease pressure relief valves are not working (stuck I suppose). When I grease the excess grease comes back out of the grease nipple.
My question is just how big a deal is this? Must I remove the spindles and fix the problem or does the fact that the grease is coming back out around the grease nipple give me confidence I'm not over greasing?
TIA, Peter
I have recently replaced all three cutter blade spindles on my scag cheetah. I have installed the new spindles and, unfortunately, decided to grease them post installation.
My problem is that two of the grease pressure relief valves are not working (stuck I suppose). When I grease the excess grease comes back out of the grease nipple.
My question is just how big a deal is this? Must I remove the spindles and fix the problem or does the fact that the grease is coming back out around the grease nipple give me confidence I'm not over greasing?
TIA, Peter