Replaced coil, still no spark. I am thinking I probably should have ordered a condenser also. By the way only way for me to find parts is EBay, straight from China of course so just hoping they are good. Anyway in Checking the condenser, I am on 20k ohm setting, Red probe to wire, black too body, meter just stays at 1, should I not see a certain ohm reading? Thanks for any help.........I am adding an edit here because, it turned out it was the coil I just damaged the primary wire installing the new one. The aftermarket coil wires came more out of the bottom then OEM coil and they were hard to not get pinched. Anyway if I would have been better with my ohm meter would have realized right away coil was bad because ohms on secondary winding(spark plug to ground) was something like 37000 ohms. New one was 9800. Anyway hope this helps someone, unfortunately I screwed up and pinched a wire so was a little confusing when I realized I had intermittent ohm readings on primary, which is what led me too the mostly broken wire. Also sorry this is so long. Great site by the way.
Last edited: