Latest activity

Pull the upper cover and air cleaner off/ out of the way then operate the throttle to verify the choke is working freely and releasing...

most likely you have a fuel or carburation problem. Check the oil too to be sure it isn't filled with gasoline that has been leaking...

The tiny “bump” that you look for to be sure the compression release is working correctly is in fact the whole key to verifying if the...

Please think, of the next guy, that has to remove that cover. Use the OEM paper/rubber gasket if at all possible. Or a sealant that...

I hate it when someone hijacks a thread...Start a new thread if you have a problem as it is easier to get answers as this thread is 3...

The more they add to the plumbing the easier it is to have problems.

This is shaping up to be a used engine refit with a larger crank diameter.

be aware that the valve guide is not concentric. Each one is unique, and when the valve seats are ground, that guide angle is used as a...

ok now. I've repaired many of these heads in the past. Remove head, the guide has about 3/16" at top of head under spring. You can buy a...

I peened mine like I saw on you tube. After two mows, I checked on it again and it started comming out so I ended up just getting a new...

I have a 1992 or so Harmony 1011 riding mower that is new to me. I use it to cut the grass between my lavender rows on my farm. I used...

Who are you thanking and what are you thanking us for?

thanks!

Hello everyone, I own a Honda HRX217K6VKA self-propelled mower that was purchased new in 2021. In July, the mower stopped pulling and...

I agree with slomo, At the very most I will only use ultra gray very thinly on a good gasket to reseal a valve cover, but not just...