I just bought a used ZD326 that has a loose blade. I cant seem to tighten it. My question is does the blade take two concave washers, one above the blade and one below it?
Don't have a parts book for that model & can't access one down here
The FZ2240 I service uses 2 cupped washers under the bolt however it will clamp the blade fine with one, but the blade slips cutting tussock grass .
If yours needs 2 they will both go under the bolt not over & under the blade.
Well ,sort of.
We get diverted to the local host site which only has locally sold mowers on it.
One of the reasons why I came here in the first place
Some local franchise distributors have to pay an access fee to allow local customers to access the main web site for a lot of brands .
Too many people trying to make too much money from too small a turnover has the public locked out of a lot of web sites.
And the Kubota site had geographical lock out on it unless you are on the dealer network .
When I had a landline I could URL spoof & pretend to be in the USA or EU but now we have been saddled with the 4th world NBN that does not work any more.
The old B & S web page was the same and a lot of other sites are not accessable from OZ unless you go in via a dealer portal .
Search for a Husqvarna model from OZ that was not sold in OZ through the dealer network brings up a not found.
Same mind set as Stihl denying access to some Zama information if that model was fitted to a Stihl tool unless you go in through the dealer net .
I just bought a used ZD326 that has a loose blade. I cant seem to tighten it. My question is does the blade take two concave washers, one above the blade and one below it?
I have have 3 Kubotas. 2 wtih 60” decks and a 72” one. All have the same blade setup.
all three use two concave washers, cup end up. I use an air impact on mine to take them off and on. NeverSieze on both splines and threads. I would never run it with one washer. Not sure of others, but if that dust cover is a spacer on mine, I am in trouble. It’s made of sheet metal.
Exactly what Shady said i use battery impact they work well to take it off and install it, they have to be that tight or they will loosen up and can come off, i had that happen already
