What is Causing Raptor 54" Uneven Cut

[RhettWS]

What happened to the OP. Did he ever figure out what the issue was?

 

[kraky]

It's pretty obvious..... he was going too fast in Too Tall of grass with a low-grade mower deck with a middle-gauge wheel that was pushing the grass down and might have had the wrong blades on. He should sell his Hustler and get a mythical lawn tractor with high-speed blades and wide open discharge chute made by a manufacturer who has no regard for Consumer safety.
(OK.. I admit to being a major contributor of the Flim Flam).
Yes... time to hear if there was a REAL solution!

 

[RhettWS]

Too funny:laughing::laughing:

 

[kraky]

Ok we're gonna get rich.... we're going to get somebody to make us up a batch of these and have carscw tune us up some decks and install. We're going to need an Advisory Board ...a great location for a factory with tax incentives ...and some investors..... who's in?

https://youtu.be/qzVBpddpK2k

 

[Carscw]

I would ride that.

Here is one of mine a couple years ago.


https://youtu.be/nHypacgdFf0

 

[577jersey]

Its gonna be a little tricky to match up the blade tip speed with wheel speed on that one...lol

 

[BigRed150]

I'm having the same problem with my alpha.

Any answers yet??

 

[kraky]

I've looked at that picture a couple of times and I can't see the problem. I do see some darn thick vegetation there. Whatever you're trying to fix I would probably start by running a higher lift blade and raising the front of the desk slightly and see what happens.

 

[577jersey]

Hard to tell but from the pic it looks to be cut a little on the short side also.

 

[Dpmulvan]

I have the same problem with my SD has never cut well since new havnt messed with it yet but not really happy with hustler.