Troy-Bilt carb advice/parts?

AndyK

Member
Joined
Nov 11, 2017
Threads
5
Messages
13
Local mower shop told me they couldn't get parts for my machine. Troy-Bilt model 31AM2P5B711 Motor says SN: 370-SUB0906052A1206 (I can't really tell what kind of engine this is.)

This started with the machine leaking gas, took carb off, cleaned, used gasket sealer, put back together and the only way this will keep running is to constantly hit the primer bulb.
Do I need a carburetor kit? Where would I get one? Should I give up?

Thanks much for any advice!!!
Andy
 

Fish

Lawn Pro
Joined
Aug 2, 2013
Threads
11
Messages
5,143
Take a pic of your engine and post it here.
Why did you use gasket sealer? If it is a standard bowl carb, remove the nut on the bottom and look at it. If you see little holes in the threads of it at top, clean them all out the best you can, and reinstall, and try it.
 

Rivets

Lawn Royalty
Joined
Mar 11, 2012
Threads
59
Messages
15,349
First of all get a new repair shop. Either the one you went to either has no idea of what they are doing or have never worked on any MTD equipment. Personally I think both are true, with an emphasis on the first one. From the numbers you supplied you have a 2009 Troy-Bilt Squall 21" Snow Thrower.
A new carb is available, MTD part number 951-14026A. If you can find a better repair shop or repair mechanic the major carb overhaul kit is available, MTD part number 951-12788A. I repeat, RUN VERY FAST from that other place.
 

Scrubcadet10

Moderator
Staff member
Joined
Sep 24, 2017
Threads
267
Messages
6,640
first of all, check your engine oil level, be sure it isn't over the Full mark or smells like gasoline.
it appears to use a Honda or Chinese honda clone engine...
Carb: https://www.partstree.com/parts/troy-bilt-951-10638/
Carb rebuild kit: https://www.partstree.com/parts/troy-bilt-951-11021/
 

Rivets

Lawn Royalty
Joined
Mar 11, 2012
Threads
59
Messages
15,349
Scrub, can you tell me where the two of us came up with different part numbers. I used partstree also. 2008 and 2009 use the same carb.
 

Scrubcadet10

Moderator
Staff member
Joined
Sep 24, 2017
Threads
267
Messages
6,640
part numbers were superseded
 

Rivets

Lawn Royalty
Joined
Mar 11, 2012
Threads
59
Messages
15,349
Gotcha, I just blank out and never check old numbers when I see a superseded number. Thank you.
 

AndyK

Member
Joined
Nov 11, 2017
Threads
5
Messages
13
Thanks everyone for the help - really appreciate it!!! Took carburetor apart (again), took out small screw inside, cleaned everything (again) put it back together, same results. Did check the oil level and it was way overfilled and seemed thin. Not sure what this means. It started again right away but I have to keep pushing the primer to keep it going. Next steps? This machine is so old that I don't want to spend too much on it. Again, thanks so much for the help!!
 
Top