Thank you for the information. I removed the carburetor today and have it soaking in gumout cleaner overnight. Will pick up the parts you mentioned tomorrow, put everything back together, I hope, and try it out. I have cleaned out all the holes in the carburetor that i can find. However, there is one hole that i can't get a fine needle into. I wish I could take a picture but my camera won't take closeups. I will expain best I can.
If you look at the air filter end of the carburetor, you will see a small hole on the left face of the flange just below the flange bolt hole. Just inside the carburetor adjacent to the hole in the face of the flange, there appears to be another very small hole that looks like it should go straight into the carburetor. I tried pushing a very fine sewing needle into this hole, but it will only go in a very short distance. I am wondering if this is really a jet or not. It almost looks like the material where this hole is might be brass, but looks might be deceiving. I would appreciate your comments.