Afternoon, hoping someone can assist. I received this generator with no spark. I replaced the spark plug, coil and wire and ensured the magnet is clean and magnetized. When installing the coil it's gapped to .016. I also ensured the grounds were clean as well. I attached photos of what I'm working with. It's a pretty simple engine so I'm not understanding why there's no spark. Any assistance would be appreciated.
Another question I have is regarding the switch on the front? What is the point because it doesn't receive power so what does connecting anything to it actually do? In the picture below there's a black wire connected at the engine (possibly vacum) and the low oil sensor. Assuming those plug into the switch?
Another question I have is regarding the switch on the front? What is the point because it doesn't receive power so what does connecting anything to it actually do? In the picture below there's a black wire connected at the engine (possibly vacum) and the low oil sensor. Assuming those plug into the switch?