Murray 11/36 Deck Bearings / Jackshaft HELP

D

doctorold

Forum Newbie
I have a Murray model 7-36508 11/36, 11HP with 36" cut, riding mower that broke a belt at the end of last season. I have been using my backup mower but I do not want to put money into it right now when it would be better spent on the 11/36.

I am unsure of the proper method to disassemble the Jackshaft Assembly for repair or replacement. I have replaced the bearings in one of my others before but this model does not have a nut on top of the jackshaft. Any assistance is greatly appreciated. I attached a couple of pictures, if more are needed let me know.

001.jpg
002.jpg
 
Mikel1 said:
I just see the blade adapter and the washer above the blade. I will add the link for you, a side note zoom in and go down.
Lawn Mower Model 7-36508 | ToolPartsDirect.com
Click to expand...

That is what I meant. I believe that is what is acting as the nut on the bottom. So, the question is, how do I hold the shaft to remove the blade adapter? My guess is a plumbers pipe wrench positioned just below the pulley. I was hoping that someone had removed one like this before and would know exactly how to do it. I can fix most anything, but a little help goes a long way sometimes.
 
You must log in or register to reply here.
Back
Top