Ms230 starting issues after use

[canadanorth3030]

Starts fine, works fine until I stops the saw. Then no start, its like it gets hot. Let it cool down for awhile and starts perfect most times. I can used it for it til it runs out if gas but If I stop in between... No Start!I changed carb, coil, gooseneck. But this issue was there from new. Far from dealer ti service do I never bothered years ago now lol.

 

[bertsmobile1]

Remove the kill wire from the coil.
This means that you will have to choke then open the throttle to stop it so it is only a diagnostic proceedure .
Problem goes away = wires shorting out when hot .
Problem remains = carb not adjusted properly, most likely too rich on the Low jet .

 

[Fish]

When you try to restart it hot, Hold the trigger all of the way down, and use absolutely no choke, and try to start it. See what happens.