John Deere LA 115 deck leveling off
- Thread starter [email protected]
- Start date
bertsmobile1
Lawn Royalty
Your deck is low on the left side
Or you left tyre is flat.
There should be adjustments on both of the rear deck hangers ( the ones that rais & lower the deck ).
Raise the left and lower the right by the same amount.
then check the front back, front should be around 1/4" lower than the back.
Your manual is readable on the John Deere web site and that is the full service manual.
However you can only read ( or print ) one small section at a time.
Or you left tyre is flat.
There should be adjustments on both of the rear deck hangers ( the ones that rais & lower the deck ).
Raise the left and lower the right by the same amount.
then check the front back, front should be around 1/4" lower than the back.
Your manual is readable on the John Deere web site and that is the full service manual.
However you can only read ( or print ) one small section at a time.
bertsmobile1
Lawn Royalty
Having a second look, i mitt be a good idea to take the deck off and check the lugs it hangs off.
There is a better than average chance if this is a sudden occurence then he deck may have cracked or one of the hangers on the mower may have broken,
The tech hangers are hard to check properly with the deck on the mower.
There is a better than average chance if this is a sudden occurence then he deck may have cracked or one of the hangers on the mower may have broken,
The tech hangers are hard to check properly with the deck on the mower.
[email protected]
Forum Newbie
Mission Accomplished !
Today I got the mower in the garage, I checked the tires only to find the pressure was way off.
I had 8lbs in the rf, 0 lbs in the lf, 9lbs in the rr, and 10.5 lr. so after adjusting them all, I then checked the blade height.
Still off but closer, so I adjusted the rear riser rods and after raising the left side, I had to lower the right side. I just cut the lawn and its much better
not perfect but a lot better.
thanks for every ones help.
John in NC
Today I got the mower in the garage, I checked the tires only to find the pressure was way off.
I had 8lbs in the rf, 0 lbs in the lf, 9lbs in the rr, and 10.5 lr. so after adjusting them all, I then checked the blade height.
Still off but closer, so I adjusted the rear riser rods and after raising the left side, I had to lower the right side. I just cut the lawn and its much better
not perfect but a lot better.
thanks for every ones help.
John in NC