I have a 2007 JD 757. Bought it earlier this summer with only 660 hrs. on it. Been running great, then a week ago it just stopped running cutting my yard. My son helped me trouble shoot and this is what we found. Starts up fine and continues running when i release the parking brake. AS SOON AS I engage the handles to move it, it cuts off. Either arm and it will cut off. BUT, if I engage the PTO blades, it will move. as soon as the PTO is shut off, if the handles are pulled in, it cuts off. We checked all the wires seat switch, replaced the PTO switch. same results, no change. Even tried bypassing the seat safety switch, no change. I'm stumped!
JD 757 only runs and moves when the PTO blades are engaged.
- Thread starter rhuether
- Start date
Auto Doc's
Lawn Addict
Remove the right console cover and locate the plug-in "box diode". Remove it and see if it all works them. The seat switch is also common to wear the harness and short to the seat frame.
StarTech
Lawn Royalty
IF seat switch is shorting to ground it would be blowing the 20A [F3] fuse. It is a +12v circuit, not a ground circuit.
Which one is a box diode? I see 4 relays, 2 orange things that only have 2 wire connections each, and a small 3 plug connection that maybe a relay. Thank you.
Auto Doc's
Lawn Addict
We need the product ID label information off of the rear chassis of the unit to determine if it is an early or later production model. John Deere made a lot of changes during production, so the year model does not tell up much.
DOM May 2007, Production Number TC0757B065476 25HP 60" 7 Iron Deck
Thank you. It has 2 of these. Going to stop by the local JD dealer (hour drive) and see if they will test these and the relays for me tomorrow. Of course, my relay tester cannot test these relays because they are designed with a sleeve covering the prongs.