If there is a good way to store a curved shaft trimmer in the garage I haven't discovered the best technique. Tell me how you store yours. Engine stuffed in a bucket, hanging, engine up , engine down, horizontal ( I'd prefer on a wall ).
#2
lawn mower fanatic
I have both of my trimmers on the wall. The following picture is how I have my Echo SRM-225 stored. I use a hanger that is made for shovels and rakes, but it works great for trimmers! :thumbsup:
#3
midnite rider
I place the handles of my trimmers in J hooks hanging from the ceiling.
#4
BHLC
I've got the same brackets as Fanatic, lowes $10 and change a piece...
I have a lot of those in my garage, too. I use them to hang my wheelbarrow and other things! :thumbsup:
#8
Briana
Welcome to LawnMowerForum!
I moved your thread to the General Mower Discussion forum. General trimmer discussions are welcome here as well. :smile:
#9
pugaltitude
I use prax holders on my showroom display.
To hold a strimmer I had to make a frame and screw the holders to it.
The frame has to be about 7" from wall to due to engine and guard.
I use one at the top and bottom.
Very secure and they dont fall off.
Only thing is you have to make a frame.
BHLC,
They've got'em in yellow at Lowes if that'll help match your decor:0)
P.S.
I space'em apart on the ceiling and hang the front & rear tire of my bicycle and my wife's bicycle each upside down on a set to clear up floor space. They are handy for a lot of things as posters have pointed out.
Yep, they are in the studs. I also hang up some of the bikes using them.....but not the one I ride most often! :smile:
#14
wjjones
I made a rack kinda like the ones that go on a trailer it is made from 2x4s I mounted to my wall in the building, and just place it in there. I will try to get a picture on here of it a.s.a.p.
I made a rack kinda like the ones that go on a trailer it is made from 2x4s I mounted to my wall in the building, and just place it in there. I will try to get a picture on here of it a.s.a.p.
