I had problems starting my JD zero turn with B&S Vtech. Would start only if I put drops of fuel on air filter. This got worse until I finally changed carb with OEM. Ran great for a couple days then would die while running as if out of gas. I had put on a manual gas shutoff while swapping carb. Lucky I did because I had solenoid fail and gas leak thru muffler. Anyway I changed solenoid and it started fine then same thing died as running. I have found if I manually shut gas it will finally start and run a few minutes then start to die. If I turn gas shutoff on it will run longer then again start to die. I’m thinking the float is stuck or faulty allowing gas to flow despite need. Does that make sense or am I looking at wrong cause?
Thanks for any help.
Thanks for any help.