Export thread

building a pulling tractor?

#1

L

lm002

Hello all,
How exactly do you modify an engine and/or tractor to make it a pulling tractor? I have been thinking about it for awhile and i have a good selection of engines and lawn/garden tractors i just don't know what to do or how to do it. Any suggestions will be appreciated.
thanks,
lm002


#2

K

KennyV

There is a lot to read about pulling garden tractors at: Introduction to the Sport of Garden Tractor Pulling!

Check around for your local club rules... have fun & post some pictures when you can.... :smile:KennyV


#3

L

lm racer

there are good ideas on google


#4

Flintmotorsports

Flintmotorsports

the best tractor for pulling is a old cub cadet or a wheel horse with a k series kohler the axle is far ahead and you can put your weight out front further where are you located?


#5

Carscw

Carscw

As far as pulley set up you have to play with it a little but I have found that a 6 inch in the front and a 4 inch in the rear works good for low and high rpm power. Some guys run same size pulley front and rear.

image-4159632010.png

This is a pic of a good clutch set up no belt slip even when wet and playing in the mud. I can send you a link on it if you like

Sent from my iPhone using LMF


Top