Briggs and Stratton V twin electric info needed

[wmg2]

I recently bought a 14hp V twin Briggs engine that originally came out of a Cub Cadet, model unknown, and I am putting it into my Snapper rear rider, more work than I thought it was going to be but love the challenge. The model# of the Briggs is 294777, type 0035-01. I need to know what the wires are for that stick out of this engine so I can make the proper connections for the new install.

 

[Fish]

The wiring of any briggs is determined by the size Alt/magnets/regulator.

So you need to describe the regulator, color of wires, etc.

Here is a chart.

http://img.docstoccdn.com/thumb/orig/9860338.png

 

[EngineMan]

When you say "stick out of this engine" do you mean the yellow one's from under the flywheel..?

 

[wmg2]

The wiring of any briggs is determined by the size Alt/magnets/regulator.

So you need to describe the regulator, color of wires, etc.

Here is a chart.

http://img.docstoccdn.com/thumb/orig/9860338.png

Fish thanks for the info. Tried to print out but only got the left side of the page any ideas how to do this. Can do it off the computer screen but not handy when in my shop

 

[wmg2]

When you say "stick out of this engine" do you mean the yellow one's from under the flywheel..?

I will take a picture later this morning and see if I can figure out how to post it and show what I mean

 

[GetTechnicalWithJd]

B&S Alternator Chart in PDF format:
http://www.powerproducts.co.za/technical/briggs_alternatorchart.pdf

 

[wmg2]

When you say "stick out of this engine" do you mean the yellow one's from under the flywheel..?

Trying to upload picture hope it comes through, need to know which of these wires is for.

 

[GetTechnicalWithJd]

Trying to upload picture hope it comes through, need to know which of these wires is for.

I have labelled the connection on the attached photo.

 

[wmg2]

I have labelled the connection on the attached photo.

View attachment 16958

Thanks for the info. Going from a single cyl. B&S to this engine what wire would be hooked up to the anti after fire solenoid?

 

[Fish]

Thanks for the info. Going from a single cyl. B&S to this engine what wire would be hooked up to the anti after fire solenoid?

You will need to connect to a wire that is hot when the key is on and in the crank position, and not hot when the key is off, or you could just dis-able the solenoid.