Anyone know wiring pinout to Kohler CV-491 (17.5HP) on John Deere L110 ?

[FREEBIRD57]

I am trying to put a JD CV-491 engine onto a Craftsman riding mower. I know what the wiring is from the plug on the Sears mower
it is Blk=gnd, Red= hot on run and start, Blue - short to gnd when key is turned off to stop motor.
The Kohler engine (from an L110) has 3 wires going in, a black, white and red. The white is probably the engine stop wire?? Not
sure on the wires into the motor. Does anybody have info. on this? Thanks !

 

[bertsmobile1]

Take the blower housing off & see where they go
Alternator should have another plug on it so the alternator can be replaced
Magneto ( coils ) wire to short out & stop the engine that will go open & closed circuit to ground with ignition on & off .
fuel solenoid goes 0 to battery voltage to open the fuel passage.

 

[FREEBIRD57]

Thanks - I will give this a try and post results.

 

[FREEBIRD57]

Took cowling off. The white wire is the engine "kill" wire. The red wire goes to the fuel solenoid. The Black wire goes to the
center of the 3 terminal regulator that is attached to the housing.