21HP V-Twin Head Gasket Repair

[Alan46]

You guys should get a room!

 

[Craftsman Garage]

Wdym?

 

[Alan46]

Just my sense of humor, don’t be offended!

 

[oldlawnguy]

I just picked up a Craftsman LT1000 with a 21HP Briggs V-Twin, model number 407577-0283-E1. I believe it needs new head gaskets, I have ordered the gasket kits but I was just wondering if I need to order new head bolts too? In the past I have ran into issues reusing head bolts and them snapping in the block while torquing them down. I was also wondering what the torque specs are for the head bolts, and how many stages I should torque them down and how many foot pounds for each stage. I’m 18 and fairly new to this, so any help would be appreciated.

Search this forum for the thread:

B&S Valve Adjustment Hiccup (Murphy's law & not a pro)​

I replaced both head gaskets on a 24HP B&S V-Twin and the gang helped me through it with specs, tips and pointers. You probably want to get gaskets for muffler assembly, carb assembly as well. Torque the head in the suggested pattern.

 

[Hammermechanicman]

If it popping back through the carb after long storage probably was stored with the intake valve open and it rusted some so it is stuck open. Easy fix. Take the valve cover off and check.

 

[rhkraft]

I just picked up a Craftsman LT1000 with a 21HP Briggs V-Twin, model number 407577-0283-E1. I believe it needs new head gaskets, I have ordered the gasket kits but I was just wondering if I need to order new head bolts too? In the past I have ran into issues reusing head bolts and them snapping in the block while torquing them down. I was also wondering what the torque specs are for the head bolts, and how many stages I should torque them down and how many foot pounds for each stage. I’m 18 and fairly new to this, so any help would be appreciated.

Probably over torqued if you broke them. On these little engines you set the torque in your elbow. Usually around 225 inch Lbs. Divide that by 12 to get ft lbs or 18.75 ft lbs. That becomes 18.75 lbs on a 12 inch lever. That is not much! estimate by picking up 2 1/2 gallons of water in a bucket ( Water is 8 lbs/gal). That's how pull you have to put on a 12 inch wrench handle. Use a criss/cross pattern a little at a time. On truck lug nuts that require 150 ft/lbs, use the lug nut wrench and step on the handle. If you weigh 150 lbs your on. If you weigh 200, add about 3/4 th of you weight.. Now, when you are done try to turn it a little more with you cross wrench. If you make it turn a little feel the force with your arms. You'll figure it out.

 

[Craftsman Garage]

@Alan46 did you mean a chat room?