engine

G'day all Got a TS 142T husqvarna fitted with a Loncin CC HV764 engine Displays typical no ACR symptoms so after wasting a day trying to find the specs for the engine , I thought i might just have a stab After fighting with the glued on rocker covers for an hour I find every rocker has a...

I have a Briggs and Stratton model 17AC2ACG055, 21 hp intex engine that I’m suspecting needs a camshaft. It was cranking and running great then suddenly it was hard to start. The engine would barely turn over, sometimes it would act as though the engine was locked up. I’m guessing this is due...

My 2022 Troy Bilt Pony lawn tractor starts and runs fine. I can engage the mower deck with no problem. But whenever I release the parking brake and engage the clutch, the engine bogs down and eventually dies. Doesn't matter what speed is selected, where the throttle is set, or what gear is...

My Honda HRN 21 inch mower had some debris & caked up oil on the block of the engine and I was wondering if it’s safe to spray on a degreaser ( heat the engine first?) on the engine and then spray the entire engine with water from a pump sprayed.Is this the best way to clean the mower?

Hello, this is my first post so I am it sure if there a typical process making a post but I'll do my best to be right to the point to not belong winded but include some details/symptoms I feel might need to be considered . I have a a S100 17.4 HP Briggs and Statin mover. Engine model 31R977...

I have a Hustler Zero Turn with about 1500 hours on it and recently the Honda engine has been leaking some oil from the bottom in the area of the vertical shaft. I tried to include a photo, but apparently "it's too large to process". In any event, I am assuming a seal or gasket has failed...

Hi I have a Stiga ride on with a B&S 12hp motor, that is seized. I have been offered a Honda GXV 390 13HP motor. Is this a feasible swap, in terms of mechanical mounting? Thanks

Hi,trying to set carb with one of these idle is no problem but high revs it wont give me a steady reading.I have tried with and without the cable.The instructions I have mention using the mode and set buttons depending on engine type and cylinder number.Now in the instructions when you press the...

I got an areins lawn mower for free and the previous person ripped all of the wiring out and I have to start from scratch. I dont plan on redoing all the wiring like it was originally, I just want the seat. Is there a way to wire it up a kill switch where if I get out of the seat it would not...

please delete

I'm looking for a muffler for my ZTH6127 mower.

I built this log splitter about 25 years ago and it has split may tons of wood during that time. I changed the oil about a month ago and a few days ago I started it and it had a knock. I've started it several times and it knocks every time. The engine numbers are 252417 5526 01 and I assume this...

Hi all. I need to remove the engine from my Hayter Hobby 41 mower. The engine is a Briggs and Stratton unit: Model: 94502 Type: 5911-02 Code: 88072804 The flywheel (underneath, where the blade mounts) needs to be removed from the crank to get the engine out. I suspect it is a push fit with...

The mower has a Honda V560 engine with a carburetor that's not getting fuel to the engine and no start. If you add a little fuel into the carburetor throat it starts on the first pull, but quickly dies. The tank is clean, the fuel new and there is a new inline filter installed. There is fuel in...

I have a bolens bl41can 0 tiller with a bad engine. I have a Stihl f38 trimmer and an echo trimmer with good engines. Can I use the trimmer engines on the tiller?

Trying to replace a Briggs model 217802 onto a Swisher 44 inch finish cut pull behind with a new Briggs 11.5 hp E1150 model and unsure what fuel tank to use since engine does not come with one. Also how to mount to the engine?

Just curious if a Kawasaki engine out of a JD 175 which is a 14hp will fit/work in a JD 240. These two lawn tractors are about the same age relative to years produced. I know the 240 had a pressurized oil lubrication system and oil filter but not sure if the 175 has the oil filter. Looks like...