Search results

Peerless manual (for similar 920 series) states, screw head level plus 1 full turn. I read a forum post, stating - screw head level for 4360 series Dana. I prefer to not totally trust my "elderly" memory. ;) Peerless has 1 detent screw. Dana 4360-55 has 2. Thanx for your experience!

Per Tecumseh/Peerless manual, images of 920 series Peerless appears same as Dana 4360. And, dis-assembly (pretty much) follows steps in Peerless manual. I have Not Found any actual cross references. I need clutch keys, axle neoprene washers, at least. THX for any experience/info.

I've change both in the past (with copy of JD manual). Usual space, etc. problems. Tractor on shop floor. This time went normal. I did steps prior to adjust variator. Which I've done a couple times in the past. Turned key and starter turned enough to lock up at flywheel. Multiple times. No...

My riding mower is a Wizard w/ B&S 16hp twin and Spicer/Dana 4360-55 transaxle yr.1993 Occasional hard shifting for couple seasons. Neut to rev, neut to 1st/2nd etc. About 80% of usage. Now very frequent. Due to terrain and "sealed system" I'm sure. I know parts NA, hard to find. But...

I ran my JD216 after 'bout 18 months. Added gas, not completly empty. Cranked/ran fine for about 45 minutes. Lost power & died. Bottom line, fine surface rust in carb bowl was only possible problem I could find. Fuel to carb, compression, Ignition - good. I removed bowl/float & float...

Generator has 1990 B&S 8 HP Magnetron w/low oil shut down. When cold, it starts 2, 3 pulls. Runs for 10 to 15 minutes and cuts off. As if the switch was turned off. While running it powered a 3/4 in. driver/drill. Will not re-start until cooled off. Is the Magnetron over heating? THX for any...