Search results

Motor spins freely, tried jumping the solenoid with a large screw driver and nothing. There is power to the starter when the key is turned. Looks like the starter

All of that is good. Model # 247.288820

Hey guys, I have a Craftsman LT1500 that wont start, and by meaning it wont start it wont crank. The battery is only about 3-4 months old and has a good charge on it. When I turn the key to crank it over I get a clicking (like the starter solenoid engaging) from under seat. I didn't have time...

Hey guys, I have a Craftsman LT1500 that wont start, and by meaning it wont start it wont crank. The battery is only about 3-4 months old and has a good charge on it. When I turn the key to crank it over I get a clicking (like the starter solenoid engaging) from under seat. I didn't have time...

true! Its running and cutting grass, albeit the charging system is not hooked up

sorry for starting a shitstorm! Just looking on how to get the wiring hooked up correctly with hopes of using the regulator on the new motor.

Thanks!

Checked deck height, and yes the deck is stamped steel. I'll take a look at the blades. How do you adjust blade height if one of them needs to be adjusted? Thanks!

Hey guys, My riding mower has developed an issue while cutting grass. The right hand blade doesn't cut as low as the left hand blade. Blades have been replaced and I have checked the deck height on both sides and it appears to be ok. Any idea on what the problem could be? Thanks

Guess my post was a bit misleading, I would like to utilize the new charging system with the old wiring. Is there a way to accomplish that without having to do a ton of rewiring?

Can I switch the old setup to use the regulator on the new engine?

Hey Guys, I just recently replaced an old briggs engine (Model 31A607) 15.5hp with a 17hp engine and have a issue with the differences in the charging systems. Below are pics showing the old engine wiring compared to the new. Where do I run the red wire that has the connector? (I think that's...