Recent content by rodder98

My serial number is MZCG-8261228. (Maybe a 2011 model) I replaced the old RotoStop cable, attempted to adjust cable to 2mm brake clearance with lever engaged, but have run out of cable adjustment. (Gap too wide) Now what can I do? Also, I have no clearance between brake ring and the contact...

Thanks for the reply. Please tell me what this has to do with the generator not starting. i am using the generator outside and not connected to any building. I want to use it as a source of power out away from any buildings or other power source.

I was running it a month ago when it just quit after an hour of running. It would not start again. A few days later, I disconnected the oil pressure switch and wanted to change it, but a 1" socket is too small and a 1 1/16" is too big, so I left the oil press switch disconnected. Yesterday...

My pressure washer with a Briggs engine won't start today. I ran it last week until it ran out of gas. Two days later I tipped it over to drain the old oil out, and yesterday I put fresh oil and gas in it. I have wet fuel at the plug, I can see the spark, and I have air too. I tried a shot...

Actually, today I have a question about a Briggs and Stratton gas powered pressure washer that I bought at Lowes. It is fairly new and has no adjustments or primer bulb. It just has a slide lever for run or stop. When completely cold, it starts and runs fine. I use fresh gas. But, if I...