hlw49's latest activity
-
Hhlw49 reacted to Auto Doc's's post in the thread Sd60 leaves uncut strips of grass between blades after a pass. Any ideas why ? with
Like.
Wrong blades or upside down. I've been sold wrong blades several times. -
Hhlw49 replied to the thread Sudden start problem.I think I would see if the piston is moving up and down
-
Hhlw49 replied to the thread Help with parasitic.Did you by chance jump the seat switch? If so it will activate the fuel shut off solenoid and kill the battery in that length of time.
-
Hhlw49 replied to the thread Husqvarna LO21H48F part?.Post the 11 didget model no. can't get that model to come up
-
HI looked, turned up nothing. Double check and make sure all your numbers are correct:)
-
Hhlw49 replied to the thread Tire sizes on a CZ 4817.4.10 = refers to the width of the tire, measured in inches · 3.50 = refers to the distance from the outside edge of the tire to the...
-
Hhlw49 replied to the thread Which deck belt?.Black And Decker Stanley owns MTD CC Hustler
-
Hhlw49 replied to the thread Husqvarna YTH24V54 seems to have electrical issues.Sounds like a charging system problem
-
HHusqvarna
-
Hhlw49 replied to the thread Which deck belt?.can't read the model no.
-
Hhlw49 replied to the thread Which deck belt?.can't read the model no.
-
HEver had a case where all the engines were working one day then after a storm have 5 coils failures the very next day? So glad they...
-
Hhlw49 reacted to Auto Doc's's post in the thread Kholer Courage 25HP Vtwin stalls when warm and under load with Like.
Next suggestion is to remove the top fan/ engine cover and clean the engine cooling fins. Air cooled engines are critical about proper...
-
Hhlw49 reacted to ILENGINE's post in the thread Kholer Courage 25HP Vtwin stalls when warm and under load with Like.
Depending on year of mower there is the possibility of a clogged fuel cap vent. Also there could be debris in the fuel tank that is...
-
Hhlw49 replied to the thread intek 12.5 hp engine cylinder head gasket need to confirm part #.Yes you are right about the 1/4 past TDC never tried the one valve fully open and adjust the other one. I will have to try it on the...