hlw49's latest activity
-
HSince The cheapest MTD mower is over $2200.00 and the Husqvarna is $2899.99 what would be a fair price for a good used mower? Around...
-
Hhlw49 replied to the thread First Oil Change.Cheapest basic MTD is over $2000.00 Husqvarna 46-inch cut 22 HP is $2899.99
-
Hhlw49 reacted to Auto Doc's's post in the thread Advice on what brand is most reliable these days with
Like.
The fewer bells and whistles the better. Engineers have gone off the deep end with all the fancy electronics and push buttons. I still... -
Hhlw49 reacted to Scrubcadet10's post in the thread Advice on what brand is most reliable these days with Like.
I like the Husqvarna YTH models
-
Hhlw49 replied to the thread Hate working on one someone else started.Was not that lucky. Ground up the magnets and wiped out the stator even burnt up the regulator terminals. Yes, I have seen that done...
-
Hhlw49 replied to the thread Steep Hill.Best zero turn I have seen for a hill is one with a steering wheel like the Cub Cadets. I have always said they made the zero turn...
-
Hhlw49 replied to the thread Hate working on one someone else started.Anyway, she called me to let me know she had mowed her whole yard, she has a large yard. She was really tickled to get it mowed.
-
HJust did a hustler super Z a widow lady has that someone else starter to work on and quit. Kohler CV740 that had a SAM box on it. He...
-
HFYI, the crankshaft length is the distance from the underside of the mounting flange of the engine, not just the part exposed beyond the...
-
HNeither does Kohler. However, many mower manufacturers say to change the oil early in their operators manuals. It's best to follow the...
-
Hhlw49 replied to the thread Toro Max 77504 creeps forward in neutral.Where I use to work did a PDI on every mower that went out the door. We had very few come backs.
-
Hhlw49 replied to the thread First Oil Change.Kawasaki does not specify a 5-hour oil change any more.
-
Hhlw49 reacted to StarTech's post in the thread Kubota Z421 - Hard to get blades spinning. with Like.
Checking the engine charging voltage also check clutch air gaps. 3. With feeler gauge check gap at all three locations (minimum of...
-
Hhlw49 replied to the thread Snapper RER.You have to understand how to operate the Snapper RER. You always start out in 1st speed you then shift to higher speeds without...
-
Hhlw49 replied to the thread Briggs and stratton 24hp vtwin vertical.why does Briggs use aluminum push rods? Do you know of any other manufacturer that uses them?