Recent content by HemiMoparGuy1981

So to add to the knowledge bank. One of the drive handles wasn't in neutral. I didn't think to check it cuz usually it won't crank when it's engaged. But once I hooked jumper cables to it to try starting it after draining the battery yesterday trying to get it back started after my wife ran it...

53AI3AGV750 1C147Z0007 Enforcer 48 Fab 03/2007 Have the tag pic on phone, but not motor info

I have an Enforcer zeroturn. It's making an odd noise while cranking. I notice the drive pumps spinning while cranking and I don't see any sticks or anything impeding the fans. Doesn't make much sense to me for them to spin while cranking starter. Also, seems to not want to crank fast enough to...

Right, I get that...it is powered by the magnetism...But with the primary coil internally grounded, the spark powered by the magnets goes right to ground instead of charging the secondary and creating a spark. But I have 3 coils that are internally grounded at the kill wire, and no spark with...

It just doesn't make any sense though...releasing the handle creates a connection to ground for the kill wire....so logically, grounding the kill terminal removes power from the coil. If the kill terminal is grounded internally to the coil frame, then the frame of the coil is bolted to the...

Ok, I'm at a loss. 3 coils, 2 brand new all ohm out with the kill terminal grounded internally, starting to wonder if it is normal

I mean, I get that it can cause a no start issue by wrong position of choke, but, I don't see how it'd cause a no spark issue and why you have to replace both the coil and the air vane

grounding plug to head bolt

I just noticed in the parts diagram it says to order a new air vane when replacing the coil...doesn't make much sense to me, can someone shed some light on that?

No spark even when unplugging kill wire

Well, it says cyl side and this side out. I tried spinning flywheel both directions too, so even if it was upside down, wouldn't reverse rotation cause spark? I think I may have found the possible issue...the kill terminal on coil itself, even when completely removed from mower, shows short to...

Hey Guys, I have a Briggs 126T02-0675-B2 that isn't getting spark. I ohmmed out the coil, determined it to be bad, replaced it, as well as the spark plug. Still no spark. I ohmmed out new coil, seems good, I ohmmed the kill wire and seems to function as it should with the lever. I checked the...