Recent content by cbr7380

bought a deck belt for a YTH1842 model # 223810 ripped,not all the way into but ruined it nonetheless a few minutes after I installed it and mowed around five minutes. I might not have ran the belt through the two hook guides on each side of the front near the front pulley. Do you think that was...

okay I tried the screwdriver and still doesn't fire it right off also as a side note I have a solenoid with two red wires (cables) on the positive post and the black ground on the other post

okay so @StarTech and @johniii so today I got the new terminal in housing etc and it fired right off several times in a row but then back to the not firin up..I started noticing on the starter that the gear with the teeth is only going all the way up properly every so often and then it starts...

yeah that was the issue with the old terminal,it would just come right out of housing with the slightest pressure

@StarTech okay I found an old terminal in the garage the correct size. It has about 4-5 inches of wire already attached to it. My question is Could I just strip some of the B wire and use a crimp connector to attach B wire to the wire attached to the terminal I found?

yeah thats what i'm wondering when i tinker with the armature it fires off perfectly then a lil later won't turn the engine over

also is this the correct terminal for that rotary housing...

and that housing you showed me from rotary will fit into this ignition switch?

I sure appreciate your help

would this also work? @StarTech https://www.amazon.com/HD-Switch-Ignition-Husqvarna-539107541/dp/B08HL8FRHP/ref=sr_1_3?crid=EY6VPMVQPNSO&keywords=husqvarna+ignition+switch+kit&qid=1689293363&s=lawn-garden&sprefix=husqvarna+ignition+switch+kit%2Clawngarden%2C116&sr=1-3

this is the one I have

it looks kinda like the red one but no matter how far I try to push it into the terminal hole it goes in maybe a 1/4 of the way?

hey @StarTech I got those connectors but theyre too big to go far enough up in the harness?

think the wire is bad going into the terminal connector? its kinda kinked due to pushing back up into the harness

yeah a fuse by the battery and solenoid its okay