Recent content by BigBlueEdge

In MN the only non-oxy (non-ethanol) gasoline is 92 octane. Unsure why that might be. But it obviously makes it quite a bit more costly than standard 87 octane ethanol gas. The last time I put some in my cycle it was probably $4.65/gal for non-oxy 92 when 87 regular unleaded was about $3.90. For...

Well, if you're in CA that may explain the differences in experiences. I'm sure CA's gas formulation isn't the same as what we have in MN.

I've used standard (ethanol-containing) gasoline in every engine I run, with the exception of small 2-strokes like my chainsaws and weed trimmer (primarily because the mixed fuel for those sits for a long time). I have never had a problem with any of the things people say ethanol does to carbs...

You can get them direct from Bad Boy but your dealer is probably the best spot to go. https://www.badboylawnmowerparts.com

Definitely look for set screws. Possibly multiple. I was attempting to remove the pulley from the hydro pumps last year to check for the recall notice on my Rogue (key installed at factory was potentially too short) and couldn't get it off even after loosening a set screw. Instead of destroying...

Thanks for looking at them. Appreciate it.

Thanks. I had my eyes on those. Or an almost identical set that is a spot/flood combo. But I've been looking for the smaller round bullet/pod style like BB uses, just to keep them in close so they don't catch on trees I mow around. Rob