Recent content by ACF

replaced the carburetor, the unit will still only start with starting fluid will run good and start and stop no problem, but if sets over night the unit will not start unless starting fliud used, new coils, new stator, new starter, could it be timing issue thanks for help

b/s 40h777-0168-e1 will only start when starting fluid is used, once starts runs good, carb has been cleaned fuel pump is working any suggestions would be great thanks ac

got sterns key switch in replaced no change , did change the wiring took the red wire that was connected to b on jd switch and changed out with purple wire got nothing

set valves to .012 did compression check got 140 psi on each cylinder so why when valves set to correct specs it drops off to 60 psi

i picked up the following one from john deere dealership tca22740 and the drawing i sent was from the one i got from john deere

here is a drawing of the john deere factory key switch pin arrangement and the wire color of each wire in them, only have 12 volts on red wire which is the battery, the data for the pins can off of the switch it self that was punched into thee pins as you tell 2 are on not labeled thanks for...

replaced key switch still wanted to start in the run position what now lol

here is the setup for the wiring for transplant engine, kill switch is wired from coils to light switch to battery ground key switch s - goes to small lug on solenoid b- to large post on solenoid r- rectifier I - carb a- not connected to anything with key switch turned to run position b- 12...

will check that out in morning, but would both go out at same time , have coil going to light switch to kill engine

placed this engine 40h777-0168-e1 in a old john deere had to install new key switch, solenoid, and rewire, engine has been starting up and running good then for some reason will not start now, checked for spark on both cylinder's none, disconnected the coil ground wire still no spark, any clues...

have a xt2 13wia4cn010 that will not start and clutch will not engage, replace ignition switch and pto switch no change, did a wiring check everything looked good, so i am at a total loss as where to go now would like any help thanks in advance AC

owner tells me that he had to replace 2 starters and had the key switch replaced, not sure if key is oem or aftermarket

finally completed the wiring checks found not broken wires and all safety switches are working properly, got it to turn over, but have a new problem when the key switch gets to the run position the engine try's to start vice waiting till it gets to the start position on the key switch and the...

found that the steering shaft was damaged where it fit into the steering gear assembly thanks for help

finally got the guard off for spark arrester and it was clogged thanks