06 Line the patch up so it overlaps as much as possible It is a good idea to make the patch material oversize by about 1/2 inch or so.. It needs to
09 Test tank by filling with water overnight over the hole level looking for leaks I filled the tank with water over the patch level. If you can,
08 Apply the patch on the soft body material so it welds together When you sense the material is bonded together, smooth it down with your tools li
07 Apply high heat to SOFTEN the body Heat the tank plastic first because it is bigger. then apply to the patch piece. when they are both feeling
06 Line the patch up so it overlaps as much as possible It is a good idea to make the patch material oversize by about 1/2 inch or so.. It needs to
05 Bottle Shape Comparison and clean tank with the alcohol very well You have to get anything that might get between the plastics out of the way by
04 Cut the Bottle close to shape needed Preparation and making the piece fit the hole is the key to a successful operation.
03 Doner Plastic Bottle Plastic bottles like this for alcohol are the same material and chemical tolerence. A Milk jug will work as well too, but
M

06 Line the patch up so it overlaps as much as possible It is a good idea to make the patch material oversize by about 1/2 inch or so.. It needs to

There are no comments to display.

Media information

Album
Repair plastic Mower Gas Tank
Added by
mrstan
Date added
View count
485
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Footer Links 1

Top