New profile posts

Results 141 to 150 of 490
Hi I have the same tractor and don't have the problem ( yet) however I do have problem with the drive belt breaking. I don't think I'm putting it on correctly because the picture is the manual is useless !!!. If you still have this tractor could you do me a great favor and take a picture of the bottom of the tractor showing how the belt is installed. Thanks in advance !!!!
cpurvis
cpurvis
Put your question in the correct forum, not in a profile post. You'll probably get more responses.
My JD F620 54 rear seal (popped out). oil light did’t come on)- there was ~3/8”
Oil
Seal intact and leak from left side (opposite oil cooler / oil filter side). Trying to figure if I have a bad head gasket??? And if that would dump oil , engine runs as before.long block repair it, or get a new engine and transfer muffler, controls, etc... ?? I see some on line for <$2K?
Some of these mowers have a safety switch installed so if you try to cut going in reverse it kill the engine. Some are found by the shift lever or on hydro's by the reverser petal or linkage.
can someone help me here ?
cpurvis
cpurvis
You need to re-state your problem, with as much detail as you can, in the appropriate forum for your mower. Thanks.
O
obiewancanoli
I have a time cutter 50, 2007. it seems like the drive doesn't fully engage (right side lever ) so the the throttle or power side wants to take over and push right . any help please ..
caddie3, I own a couple of Kubota Zero Turns and lover the mowing function but at times need a little help...
C
Caddie3
I presently have a ZG 222 Z with
rather stiff control levers. Any suggestions?
Had same problem. It's the "float" couple yrs ago. No gas allowed after the prime burns up. IF I REMEMBER--there is a small screw in bottom of the float tank--it has to be unscrewed and then put back in. Think it trapped some sediment or ??? Very easy to try
I have a Husqvarna 22HP riding mower. All of a sudden when I was mowing I started hearing a buzzing noise. It only happens when the blade is engaged. Any ideas? I know it's not much information but that's really all I've got.
cpurvis
cpurvis
You would get more people to see your question if you post it in the Husqvarna forum or the forum for the maker of the engine.
Top