New profile posts

Results 131 to 140 of 490
chubbdavid
Hi
Sorry to bother you, I have stumbled across this forum post that you wrote a few years ago

www.lawnmowerforum.com

Honda GXV530 intermittent problem

Hi All, I have a buddy who has a Honda GXV530 which he is having an issue with. The engine runs fine and the out of the blue it 'misfires'. They determined that when the engine was 'misfiring' it was only running on one cylinder. They checked compression which was good on both cylinders and...
www.lawnmowerforum.com www.lawnmowerforum.com

I am experiencing very similar issues, have replaced the carb and 1 ignition coil. did you and your buddy ever manage to get to the bottom of it?

Many thanks in advance,
David
GetTechnicalWithJd
GetTechnicalWithJd
Hi David,

Thanks for reaching out.

That was such a long time ago I do not recall what the resolution was. I will dig through my records and see if I can find anything that jogs my memory,
chubbdavid
chubbdavid
many thanks!
David
F
Hi I have the same tractor and don't have the problem ( yet) however I do have problem with the drive belt breaking. I don't think I'm putting it on correctly because the picture is the manual is useless !!!. If you still have this tractor could you do me a great favor and take a picture of the bottom of the tractor showing how the belt is installed. Thanks in advance !!!!
cpurvis
cpurvis
Put your question in the correct forum, not in a profile post. You'll probably get more responses.
G
My JD F620 54 rear seal (popped out). oil light did’t come on)- there was ~3/8”
Oil
Seal intact and leak from left side (opposite oil cooler / oil filter side). Trying to figure if I have a bad head gasket??? And if that would dump oil , engine runs as before.long block repair it, or get a new engine and transfer muffler, controls, etc... ?? I see some on line for <$2K?
O
Some of these mowers have a safety switch installed so if you try to cut going in reverse it kill the engine. Some are found by the shift lever or on hydro's by the reverser petal or linkage.
O
can someone help me here ?
cpurvis
cpurvis
You need to re-state your problem, with as much detail as you can, in the appropriate forum for your mower. Thanks.
O
obiewancanoli
I have a time cutter 50, 2007. it seems like the drive doesn't fully engage (right side lever ) so the the throttle or power side wants to take over and push right . any help please ..
C
caddie3, I own a couple of Kubota Zero Turns and lover the mowing function but at times need a little help...
C
Caddie3
I presently have a ZG 222 Z with
rather stiff control levers. Any suggestions?
Q
Had same problem. It's the "float" couple yrs ago. No gas allowed after the prime burns up. IF I REMEMBER--there is a small screw in bottom of the float tank--it has to be unscrewed and then put back in. Think it trapped some sediment or ??? Very easy to try

Footer Links 1

Top