Latest activity

I’ve seen GCV160 carbs for less than $20. It will depend on the full engine numbers.

I know on some engines like Briggs, if you pull the top shroud off to clean the cooling fins, that top metal shroud might not be...

XT2 is just series number that can include several different mowers within that series. So please provide the model and serial number...

Rivets has a point, but I've had pretty good luck pulling the bowl, cleaning float needle and seat, blowing carb cleaner through the...

Check battery voltage while turning the key to the start position. If battery voltage drops below 10 VDC the battery is shot and needs...

At the price of Honda carbs I wouldn’t waste time trying to clean it. I would just replace the carb.

If you feel it is rough when spinning by hand, go to dealer now. Be proactive and do not wait. Let them grease it if that’s what it...

Rough sounding while spinning IS a sign of degraded bearings. Now is the time to address this. If you don't, eventually the bearings...

Agree: That is why I suggested time to start measuring things. He said he replaced the sump that has new sleeve bearing, so it's time to...

With the belt removed and spun by hand it sounds rough but spins about the same as the other two that run silent. With belt engaged and...

Hi Tiger, I almost installed in a couple of good pushrods until I went to check the intake valves individually and they would not budge...

Ok ,it set for a few years, on my pressure washer. 8 believe I put stabill in it. Drained the fuel, started with fresh gas after several...

I will almost take bets on the crankshaft in the sump bearing area being no longer round

Hi guys. I’m not sure if I’m in the right place to ask this question but thought I’d give it a whirl. I have a snapper mgt200h withe the...

XT2 is just series number that can include several different mowers within that series. So please provide the model and serial number...