Latest activity

  • A
    Auto Doc's replied to the thread 2016 xt1 50" trans belt.
    Weve seen that a few times. I had a strange situation a few years ago where 3 different neighbors kept passing the same mower around...
  • sgkent
    sgkent replied to the thread 2016 xt1 50" trans belt.
    remember this thread. A few weeks from now someone new will indicate they just bought a mower with a transmission top that is broken...
  • S
    slomo replied to the thread FX730V Bogs under load.
    Is that the max distance the spark jumped? If so the coil is near dead. IF you have a resistor plug then your available spark is even...
    • 1786392689395.jpeg
  • S
    I would ask on here or call Kawasaki and get a shop manual. Look online for a shop manual for your engine. Next time take pictures of...
  • M
    Mark H_NO replied to the thread Mower Keeps Dying.
    That fuel pickup with a screen on it is probably a check valve. I just had a problem with one yesterday. It looked identical to yours...
  • S
    slomo replied to the thread Mower Keeps Dying.
    There's your dinner. Fuel delivery issue. Mark H_NO gave you good advice that was ignored on page one.. After fire solenoid. Stops...
  • ILENGINE
    ILENGINE replied to the thread Jonsered L2821.
    532427497 Jonsered is owned and made by Husqvarna.
  • J
    This control panel and linkage is difficult to do correctly if you're new to it. I'm in over my head. It seemed simple when I took it...
  • B
    Bmwz3coupe replied to the thread Powermore recoil.
    Thank you for your help. I had to order 3 of them before I got one that would rewind after starting mower.
  • B
    Bmwz3coupe posted the thread Jonsered L2821 in Husqvarna.
    I'm finding conflicting part numbers for the safety cable. Can you help ? Model L2821 Model 961430132 00 Super clean mower in...
    • 20260810_115329.jpg
  • M
    Mark H_NO replied to the thread FX730V Bogs under load.
    The fuel can spout reference is suggesting contaminated fuel, clogging fuel system somewhere from tank to carb. It's always worth...
  • D
    I already put a jumper wire on the seat switch connector. That is the only way I could manually crank the starter.
  • McTurff
    McTurff replied to the thread Briggs 422707 opposed twin carb.
    What spark plugs do you like to run and what rpm settings? I think low is from 1200-1400 High upto 3400 And what do you think rpms...
  • H
    Hesermon replied to the thread FX730V Bogs under load.
    Replaced both coils with known good used ones. Same exact result. Runs fine without PTP on, bogs horribly when cutting grass. Using...
    • 20260810_115403.jpg
  • McTurff
    McTurff replied to the thread Briggs 422707 opposed twin carb.
    c No screen it was just sitting on top of engine screen for flywheel! My little rubber gasket worked much better than the Fibre dyst...
Back
Top