Latest activity

Hello L., That is uncommon, but not unheard of. Check for power with a test light, but also verify the grounds are good. Do you have...

If you unplug it and check resistance and get no reading the windings are open in the PTO clutch. You will need a new clutch assembly.

Hello L., If you have a multimeter, Ohm the 2-pins going to the clutch with it disconnected from the chassis harness. If you don't get...

Can you unplug the PTO wires, and the blades still stay engaged? If so, it likely has a seized-up/ failed PTO bearing.

Hello B., Unless the carburetor is badly damaged due to water in the fuel, I suggest a full rebuild or get a replacement carburetor...

This manual may help you out. http://www.tuks.nl/WFCProject/img/Engine_Carburator/81644210-Briggs-Stratton-Service-Manual-L-Head.pdf

That is a Briggs pulsa-prime carb. From the paint looks original to the mower. Not much to repair on those. Make sure the inlet...

Aluminum will still oxidize back to a duller finish.

Oh Ok thank. ... so I'm kinda wasting my time then :-(

Hello D., Pardon the observation. but you did mention the "USA". We are in modern times where most young people are just breathing...

in retrospect it is probably advised to order parts from a local dealer if one is nearby. this way if there are any 'delivery issues'...

i shipped an Oregon bar and chain to a buddy one time.... on the trip from Texas to Florida, just the bar was taken from the package...

Hi guys, I'm working on a John Deere 997 Z-Trak for a friend and I'm trying to get the seat safety switch to work. I think it may be an...

Finally got around to where I could see the problem. Part #50 (anti-rotate bracket) was cracked and only being held together by a...

you have a point, but this is a SIMPLE transaction: customer orders parts, parts are pulled from stock & sent to shipping dept...