Latest activity

If it were my mower, I would run it level all around. If you are going to do it by the book, match your height selection to the actual...

Seafoam, no expiration date. Been around since 1942

That’s a pretty common situation, especially with small engines that sit for long stretches. Storing the mower with an empty tank isn’t...

No offense but start looking behind the air filter more often. Most filter housings are plastic. Most all of us over torque the screws...

Just note mulch up leaves will feed your lawn as they decay over the winter months.

I NEVER start my engines before I check the oil level...

I have genuine 1-1/8 V-belt drive pulley from Craftsman rider if you are interested. It has the crank key made into it.

I will give the old "college try"... and if impossible, I will have the shaft machine tooled and welded to the pulleys, professionally...

I use good-ole axel grease. These are not high speed parts. If the blade\spindle shaft is not turning freely or smoothly, the spindle...

Or the other idea would be the way a leaf blower actually does work so you have an engine and must power some sort of fan and that fan...

And just another thought about this project so you could just ignore the fact you have 20 horsepower riding mower that can spin blades...

Very frustrating going behind a customer that works on equipment and doesn’t fix it. Then you have to figure out what they have done.

Well I see you are just throwing at it as the seat switch has nothing to do the reverse inhibit working as intended. It is just that you...

So initially my post was about the something like this exist and apparently it doesn't but my idea was take a typical flat blade that...

I mean maybe take the blade and curve the surface to some angle so basically a high lift blade the main axis of the blade and the blade...