Latest activity

Hi thanks for replying and I read your reply so think of this if you're just using high lift blades and your lawn is basically cut but...

Well the issue ended up being the carburetor, I just didn't transfer a part from the old one to the new one. It's working fine now.

Interesting discussion, but I think putting paddles on the blades will try to send air, and therefore leaves off the tips of the blades...

Is there a trick or easy solution to removing the oil filter on a Kohler Courage 22 hp SV715 without oil going everywhere on frame and...

Bingo. V-pulley and V-belt wear gauges

Nope....Not even carburetor related. Here is the whole set. Although I do have both W tools and the Z tool. And the 500-13-1 on page...

I went back and looked. See my above reply. That's what I get for not using both my senses of hearing and sight together.

I did. It sounded like it was spinning just fine to me. Never mind, I wasn't paying attention to the top of the engine not spinning.

OK. That said, will it extend engine life to 'flush' these "resting areas" or are they best left alone? Let sleeping dogs lie, as it were?

Hello SamB, Nothing wrong with using a vacuum method to suction the majority of oil out through the dipstick tube. Even using the...

OK, thank you. I'll just keep up the regular oil changes/air filter,too.

I just removed the powered bagging system from my Gravely ZTX42 and installed the mulching kit. Should I remove the weights from the...

Used some Lectra-motive cleaner on the grease and wire brushed the switch. Tested OK. Started right up. Now on to why it's throwing a...

Sounds like the battery needs to be load tested to make sure it has enough amperage. A multimeter only reads voltage. Voltage is only...

So what happened was we were cruising just fine after the fixes I put in months ago, but then a couple of days ago a bot hit us (and...