Latest activity

Pulley groove wear gauges

Plug and play, new engine harness had a green wire the old one didn't have ,

Boy you are smart Scrub.

Bingo. V-pulley and V-belt wear gauges

OK, all this about what kind of gasket maker to use is more confusing to me than helpful. I pulled off the gasket cover and had no...

Thank you for your advice. I can get the mower to crank and run. Sometimes it just is difficult to start and acts like what I see in...

Drain the carburetor bowl after you check for " Fire - Spark" at the spark plug. Starting fluid initially after draining the carb bowl.

Think about this one a bit. Pull the oil dip stick out. Use that thing on the front of your face. Still need help? :geek: Sorry...

Guess you’ve never read my previous replies to what is the best push mower to purchase. I used to say that even the cost of the Toro...

Believe it or not, I replaced the OEM factory installed carburetor, with a cheaper Amazon aftermarket one, and it runs perfectly. No...

It’s the same as the automobile industry….planned obsolescence. I have 2 old mowers, a 2 stroke Lawn boy and an aluminum deck super...

Verify the tank strainer is not partially clogged, fairly common.

Did you pull the emulson tube out as well and clean all of the holes in it ? The emulson tube is the bit that pokes out into the carb...

unfortunately most people are fairly sefish. They come here with a problem an when they get it solved vanish with not so much as a thank...

I think I understand this, but read below and tell me if this make sense, or I'm not getting it right: If the mower only runs with the...