Latest activity

B&S 33R877 0033 G1

I am curious how you made out? Did you proceed with the engine rebuild or did you repower with an other engine? I am in the same or...

I never buy a clickable setting torque wrench. Like StarTech said, you must dial back to 0 when done. I just buy the old school beam...

good video you know my cable has been real constrictive the closer to choke I move it. actuely it's never been smooth. this for over 12...

Had a similar situation. Per advice on a different site more than 5 years ago, i put red thread locker on the exposed valve guide...

Did you get this fixed dana a?

when it happens that fast to allow that kind of blowby to blow oil out , a broken ring, hole forming in piston, broken guide etc. All...

Most likely it has broken compression rings or a badly worn cylinder allowing too much pressure back into the crankcase. A failed...

A tired, worn engine. Keep the oil topped off every time you use it, and run it.

Gary has left the chat.

If you can't find the specific bolt, make one. If you have a grinder....... Bolts are cheap.

Hi, I have an old Troybilt chipper shredder that the previous owner installed a 13hp Briggs on. Came with a 10hp Tec that blew...

We’ll probably never know!

If that is the case then the OP has a problem as I haven't seen a double stack pulley that is 1-1/8 ID. And I just had a problem with CC...

Don't know how many valve covers I've tried to remove. Globs of RTV all over the engine. End up bending and replacing the valve cover...