Latest activity

"thumb" typing and texting are the ruination of proper grammar and spelling. As long as 'they' can understand one another, that's all...

i wish all people posting would use punctuation it makes it so hard to read run on sentences and try to figure out what is being said i...

muriatic acid then neutralized will eat aluminum off the journal then lightly sand it, but a hogged out bearing race is a different...

Bad Gas is the standard when they have no clue . .Put Champion plugs in it .

I am working on a John Deere JX75 a 21 inch self propelled mower approx 25 yrs old it has a Kawasaki FJ180V-AS11 engine. The connecting...

Two things happen when you apply power to the wrong circuit. One is you let the "magic smoke" out and two, you likely created more...

Have you ever worked on a carburetor before? They are not to complex, but you need to take pictures as you go. The top cover has to...

First off, just what mower do you have? Did I miss that info, perhaps? But on with the show! Disregard anyone's advice about 'gears. If...

Sgkent, that is the vent as Star stated, not fuel inlet. Fuel will also leak out the fuel vent if the gasket between the carb body and...

Just a couple of thoughts. 1) as stated above, mow at full throttle. 2) don't cut while turning, do three point turns. 3) check deck for...

you have circled the fuel inlet nipple. If it is the issue then it is either loose or you have a bad hose. It is your first post here...

Not a choke issue… solenoid issue? What should the voltage be on the solenoid at startup?

disconnected switch reconnected had voltage but not constant when did have power the starter would engage only, owner reported that key...

Had a LA-135 ? that was stubborn at start up cold . Adjusted all that could should be without result . Hell, i need ta mow not monkey...

Hoping there's a solution to this, but we bought a used 72" wide Scag back in 2021 and I'm trying to figure out the serial number. I see...