Latest activity

Hi StarTech, I also had a couple fail years back because they were too thin, but the last one I got was a thicker and improved design.

When you initially reset the governor adjustment, it likely had enough room to allow the governor center pin to pop up out of place...

Why am i leaking fuel at this fitting? I removed the filter housing and top of the carb to pour some gumout in the float cavity. After...

I wanted to bring everyone up to date on this issue. After searching The Tubes I found a mechanic that discovered a similar issue. It...

Bingo!! Wifey arrived with better eyes!! 9P602 O023 F1 DOM 06-21-13 I really appreciate y'all's experience with this one....I've...

small 22 caliber directly through; but do it in the grass, not a concrete floor ..... 😱

I'm right over by Will Rogers airport on the west side...let us know what JD has to say....

Plus the ones at top top that thread into the head there are two about half way down the sides if you have an oil cooler there is not...

it's me again took star tech drawing # 2 sn 120001, did a continuity test on all the wires got a good long beep on all except for the...

The new generation are working too many jobs and helping their families to have time to worry about these details. Ya know, your thumbs...

Rivets, Thank you for your quick response. I will source a new module/coil and try again after I receive it.

I guess it's too hard to fire it up in idle and when "surging" and place both thumbs over the holes and see if it smooths out...

First off, just what mower do you have? Did I miss that info, perhaps? But on with the show! Disregard anyone's advice about 'gears. If...

They are push on speed clip retainers Sometimes you can find them at a NAPA or a parts store that has selector boxes of various sizes...

Better engineering by the design engineers would help.