Latest activity

I've used aluminum foil to form a simple funnel. Works better on some machines than others. Then throw it away. Nothing to clean up or...

Unless the blades are gear drive or clocked with a timing belt the blades will not stay clocked and will collide

Sounds like the blade is running to slow. Might want to check the belt is installed properly. Are all the pulleys the same size?

All way too complicated - I use a piece of malleable aluminium flashing (replaced lead). Can be purchased from the hardware in a small...

All way too complicated - I use a piece of malleable aluminium flashing (replaced lead). Can be purchased from the hardware in a small...

my 1.5 cents good day Sir what does the manufacturer tell you (tech rep/engineering) Good luck

Well that would leave no overlap; unless, BB is lying about the cut width as 3 x 24" is exactly 72". I have yet to see a mower with no...

That's part of what I was wondering. Mine don't appear to move because I always clock them to not meet (stock size blades which wouldn't...

Okay the center blade is offset forward. And 24-1/8 Blades are only 72-3/8 total width. And tip wear would cause the problem. So the...

Unless the blades are gear drive or clocked with a timing belt the blades will not stay clocked and will collide

Unless the blades are gear drive or clocked with a timing belt the blades will not stay clocked and will collide

So I took apart the mechanism where the starter pawls retract. There was one weird piece of plastic in there that I thought might be...

I have located numbers that are cast into the engine block, on a flat horizontal surface..."21-140"

Unless the blades are gear drive or clocked with a timing belt the blades will not stay clocked and will collide

You posted the same question on Lawnsite (another forum). How could anyone possibly know the exact spec on valve guide on that specific...