Latest activity

The pinion and rack gear need to be replaced most likely. The deck has to be removed, and the mower raised up enough for access to the...

Funny most the riders I see with the K46 have the engine in the front.

From you description I would suspect there is low compression. Maybe the valves need to be checked for proper seating. Carbon does build...

Sounds good

Good suggestion but too late. Shroud is back on. I did blow everything out with a compressor and clean the carb linkages before...

So...on an Onan two cylinder opposed, is there but one coil for both since both would fire at the same time. The only way for plugs to...

Usually, I prefer not to dry out a carburetor because the Viton tip on the needle and seat get dry and rigid. They have a hard time...

I found it. Or at least good enough for my needs.

I'm not sure if you'll find a regular mower that will cut through anything over a foot high without bogging down. Sounds like you really...

Even running an engine till it stops from no gas. There is still some left in carb fuel bowl, gotta remove bowl to have it completely empty

end of season I try to remember to fog all my engines much like a marine engine.....

interesting

:LOL:

Hi kmills74, It is unusual for the valve lash to actually get tighter, normally they get wider to a point where a push rod ends up...